Rowmark LaserMax - Laser & rotary engraving material

Specifications
Material:	Microsurfaced Impact Acrylic
Finish:	Matte non-glare Brushed Metal
Sheet Size:	24" x 49" - Full 24" x 24" - Half 12" x 24" - Quarter
Thickness 1-Ply:	NONE
Thickness 2-Ply:	1/32" (.8mm) Use LM912 as first digits of the item code. 1/16" (1.6mm) Use LM922 as first digits of the item code. 1/8" (3.2mm) Use LM942 as first digits of the item code.
Thickness 3-Ply:	NONE
Usage:	Interior signage Exterior signage Personal identification
Engraving Method:	Laser Rotating carbide
Cutting Depth:	.003" (.08mm)
Capabilities
Scores		Bonds
Saws		Permits Fine Engraving
Drills		UV Stable
Shears		Back-Filling
Laser Vector Cuts		Back-Lighting
Bevels		Braille-Engravable
Heat Bendable		Embosses
Screen Prints		Ink Prints
Hot Stamps		Thermal Prints

Physical Properties	Typical Values	ASTM Method
IZOD Impact Strength
Notched at 73°F (22.777°C)	1.2 ft lbs/in	D-256
Notched at 32°F (0°C)	.7 ft lbs/in	D-256
Tensile Strength
To break	5,400 psi	D-638
Elongation before break	35%	D-638
Flexural Strength
Loan to stretch outer surface 5%	7,000 psi	D-790
Specific Gravity	1.15	D-792
Rockwell Hardness	R99, L77	D-785
Deflection Temperature
Temperature at which material deflects .010" (.254mm) at 264 psi	170°F (53.926°C)	D-648
Coefficient of Thermal Expansion
Inch/inch/°F	3.8 x 10-5	D-696

LaserMax softens at about 200°F (93.33°C) sufficiently so that it can be bent as needed. It can be sawed, drilled and bonded, but not sheared.

The base material was tested for flammability by Underwriters Laboratories. The material is rated 94 HB on the UL 94 test.

NOTE: The above information is given in good faith, but no warranty, express or implied, is given.